|
[Sponsors] |
February 10, 2007, 06:01 |
fluent not responding
|
#1 |
Guest
Posts: n/a
|
hi I am modeling a pulse tube refrigerator.it is a 2d axisymetric unsteady problem. i am using around 3000 cell .i am using a UDF for dynamic mesh motion of the piston . it is working properly. my time step is very low i.e .0073529. so i am taking only one iteration for time step as it it is taking much time.but my problem is
Sometimes, I get the FLUENT NOT RESPONDING messsage, I waited for some time, and still the same message existed. So I closed it down. Yet, at other times (while running the same case), it just disappears without any iteration. What may the problem ? please reply ammi |
|
December 27, 2011, 04:53 |
|
#2 |
New Member
rohit mukare
Join Date: Aug 2011
Location: rourkela
Posts: 16
Rep Power: 14 |
hi i m also doing the exact problem with slight modification.i hv nt experienced this problem may be its your software problem. i wanted to ask you some doubts regarding pulse tube.
kindly reply to this msg... |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Stopping a Fluent batch job AND saving the data! Possible? | Volker Pawlik | FLUENT | 13 | December 28, 2020 04:16 |
Two questions on Fluent UDF | Steven | Fluent UDF and Scheme Programming | 7 | March 23, 2018 03:22 |
Fluent 6.3 32bit vs Fluent 12.0 64bit | ibex7 | FLUENT | 7 | April 18, 2011 02:44 |
Fluent 12.0 is worst then Fluent 6.2 | herntan | FLUENT | 5 | December 14, 2009 02:57 |
Problems in lauching FLUENT | Lourival | FLUENT | 3 | January 16, 2008 16:48 |