|
[Sponsors] |
January 27, 2012, 17:00 |
Problem with create a interface
|
#1 |
New Member
ingeniero
Join Date: Jan 2012
Posts: 2
Rep Power: 0 |
Hi friends, this is my firt time here, well my problem is I'm trying to simulate the convective heat transfer of a MiniCanal, but i am trying of many forms to crate theinterfce but it results bada all my option because the fluid don't show any heat transfer, i upload the picture of my project for any help, thanks anyway.
preview.png it see the way of the fluid. |
|
January 28, 2012, 00:15 |
|
#2 |
Senior Member
shoeb khan
Join Date: Nov 2011
Posts: 179
Rep Power: 14 |
there must be something wrong with your case putup in fluent.
Do you put up the heat transfer at the walls of the surface where you want the heat transfer to be taken place. Check your case properly shk |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
How to create interface in VOF model of ANSYS/Fluent | shambansal2010 | Fluent Multiphase | 14 | April 5, 2017 01:03 |
Actuator disk model | audrich | FLUENT | 0 | September 21, 2009 07:06 |
Interface problem | Tomislav | FLUENT | 4 | May 23, 2006 00:49 |
CAD Interface problem | sweenam | Phoenics | 0 | November 9, 2002 06:08 |