 |
 |
 |
|
|
|
[Sponsors] | ||||
reading boundary conditions data at inlet from .dat file |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 17, 2014, 04:21
|
reading boundary conditions data at inlet from .dat file
|
#1 |
|
Member
Iman
Join Date: Nov 2013
Posts: 37
Rep Power: 12  |
Hi
i have tabulated data of velocity, k and e from actual experiment in .dat type. how can i set fluent to read from this file for the inlet conditions? also if i want to set k-e using the relationship e=C*k^1.5 how and where to specify that? any help/advice or reference is highly appreciated |
|
|
|
|
|
September 17, 2014, 07:30
|
|
#2 |
|
Senior Member
Join Date: Nov 2013
Posts: 1,965
Rep Power: 26 |
You should write a UDF for that. Look in the UDF manual for DEFINE_PROFILE, there are some examples that might help you further.
|
|
|
|
|
|
|
September 17, 2014, 21:02
|
|
#3 | |
|
Member
Iman
Join Date: Nov 2013
Posts: 37
Rep Power: 12 |
Quote:
|
||
|
|
|
||
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [OpenFOAM] Annoying issue of automatic "Rescale to Data Range " with paraFoam/paraview 3.12 | keepfit | ParaView | 60 | September 18, 2013 03:23 |
| RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
| ParaView Compilation | jakaranda | OpenFOAM Installation | 3 | October 27, 2008 11:46 |
| [blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |
| Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |
1Likes
Linear Mode
