|February 7, 2012, 02:57||
shock tube setup
Join Date: Dec 2011
Posts: 28Rep Power: 7
I am tryin to simulate a M=2.1 shock wave in FLUENT. I have defined a UDF for the boundary conditions and using a courant number of 1.
Immediately after the calculation starts the values deviate a lot frm the set values and the calculation from there on goes haywire.
Can someone tell me why this is happening and wat are the things i need to look into for rectifying the problem
|Thread||Thread Starter||Forum||Replies||Last Post|
|HLL Riemann Shock Tube Matlab Problem||Luke F||Main CFD Forum||2||May 20, 2016 02:10|
|Shock tube simulation||harish||FLUENT||5||January 25, 2014 03:20|
|rhoCentralFoam not reflecting shock in Shock Tube?||Astaria||OpenFOAM Running, Solving & CFD||5||March 4, 2012 04:07|
|shock tube validation||AB||Main CFD Forum||3||December 10, 2004 08:31|
|Shock tube problem||AB||CD-adapco||1||November 9, 2004 01:25|