|
[Sponsors] |
February 12, 2012, 04:01 |
iterations not calculated
|
#1 |
Member
Abdulqadir Aziz
Join Date: Jan 2012
Posts: 45
Rep Power: 0 |
Hi everyone,
I'm attempting to run a periodic mrf of a wind turbine. I'm pretty sure all the settings are correct (periodic set to rotational, rotor zone set to mrf, etc). But fluent just wont iterate. It shows the iterating... dialogue, but that's all! I'm really frustrated right now since I couldn't find any solution to this problem. Could someone out there help me please? |
|
May 21, 2013, 05:47 |
|
#2 | |
New Member
Join Date: May 2013
Posts: 22
Rep Power: 12 |
Quote:
i have the exact problem such as what you had.my bc are like you and the fluent solves that but after displaying the velocity magnitude contours ,all the velocity magnitudes are 0 . would you plz tell me how did you solve it? it would be really helpful for me if you tell me what you did. |
||
May 21, 2013, 08:40 |
|
#4 |
New Member
Join Date: May 2013
Posts: 22
Rep Power: 12 |
||
May 21, 2013, 23:10 |
|
#5 |
Member
Abdulqadir Aziz
Join Date: Jan 2012
Posts: 45
Rep Power: 0 |
Hi all, please refer to the following thread:
http://www.cfd-online.com/Forums/flu...i-turbine.html I have resolved all the issues I had with the simulation, and put my solutions there. If you have any more questions please pm me or post it in that thread. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
High Courant Number @ icoFoam | Artex85 | OpenFOAM Running, Solving & CFD | 11 | February 16, 2017 13:40 |
Extrusion with OpenFoam problem No. Iterations 0 | Lord Kelvin | OpenFOAM Running, Solving & CFD | 8 | March 28, 2016 11:08 |
How to write k and epsilon before the abnormal end | xiuying | OpenFOAM Running, Solving & CFD | 8 | August 27, 2013 15:33 |
Orifice Plate with a fully developed flow - Problems with convergence | jonmec | OpenFOAM Running, Solving & CFD | 3 | July 28, 2011 05:24 |
Differences between serial and parallel runs | carsten | OpenFOAM Bugs | 11 | September 12, 2008 11:16 |