 |
 |
 |
|
|
|
[Sponsors] | ||||
What's the unit of heat of reaction in Fluent??? |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 14, 2012, 11:26
|
What's the unit of heat of reaction in Fluent???
|
#1 |
|
New Member
yerem
Join Date: Jan 2010
Posts: 3
Rep Power: 18  |
Hi, I'm simulating steam reforming of methane by fluent.
I have a problem with heat of reaction. When I post processing, there is a heat of reaction under reaction tab. I want to know total heat generation in volume. But the unit of heat of reaction is 'W' not 'W/m^3' how can I get the total heat generation?? |
|
|
|
|
|
December 26, 2019, 06:17
|
Have you gotten the answer?
|
#2 |
|
New Member
XH
Join Date: Oct 2014
Posts: 16
Rep Power: 13 |
I'm also confused by such question. The unit of the heat of reaction in the contour is watt. I wonder it should be watt per volume or per mass. Have you figure out what is it? Thanks a lot.
|
|
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Concentration and reaction unit | vculiu | FLUENT | 1 | June 11, 2013 07:18 |
| Conjugate heat transfer FLUENT vs CFX | pstreufert | ANSYS | 0 | October 5, 2011 16:47 |
| Calculation of heat generation in Fluent for 2D | krishnachandranr | FLUENT | 0 | April 8, 2009 00:31 |
| Problem of heat balance in Coal Boiler simulation | DG | FLUENT | 9 | December 25, 2008 21:57 |
| how to impose experimental dat as boundary conditi | Rogerio Fernandes Brito | FLUENT | 14 | November 25, 2008 06:47 |
Linear Mode
