moving zone in CSTR
Dear everyone
hi I have designed a 3D cstr in gambit and then read the msh file in fluent. as there is an impeller in the CSTR, i have defined a moving zone around the impeller. so there are different FLUID ZONEs, one for the tank and the other for moving zone, and a SOLID ZONE assigned as impeller. but when I run the case in Fluent, there is no effect of rotating moving zone on tank. you can look at; http://img4up.com/up2/40447642711168584609.jpg what should i do? thanks in advance for answers. |
is there any misunderstanding?
please help me! |
Have you seperated the two vloumes (mixer and tank) by subracting? you should subtract the mixer(retain) from tank.
|
All times are GMT -4. The time now is 21:23. |