|February 20, 2012, 21:23||
walls that should be interior (but i cant find it)
mohamed khedr emam
Join Date: Oct 2011
Posts: 121Rep Power: 7
hi guys. i am working in a H.A Wind turbine . i did make the geometry in solidworks and did the mesh in Ansys. the problem is that i have some interior faces and when i ran the fluent i have walls instead of interior bc.
i have two main zones: the one that its' close to the blades and the other one that's away. i set up a interface in between this two because the interior one is moving while the exterior is fixed.
the problem is in the wall zone. i should convert it to interior but the available types is inlet, outlet , interface, etc....
i try to use fuse option but didnt work
can anybody help me?
|Thread||Thread Starter||Forum||Replies||Last Post|
|OpenFoam171: error /usr/bin/ld: cannot find -llduSolvers||Schipper||OpenFOAM Programming & Development||5||November 15, 2012 15:13|
|OpenFOAM 1.6-ext git installation on Ubuntu 11.10 x64||Attesz||OpenFOAM Installation||45||January 13, 2012 13:38|
|Problem Building OF on Centos cluster (no admin rights)||CKH||OpenFOAM Installation||5||November 13, 2011 07:32|
|Converting Starccm+ mesh||Ladnam||OpenFOAM||0||September 14, 2011 06:30|
|YPlus nowhere to be find||Daniel||CFX||3||May 1, 2006 16:22|