Home > Forums > Software User Forums > ANSYS > FLUENT

Laminar Finite-rate model Reaction Heat Release adjustment

Mark Forums Read

Reply

Search this Thread

March 6, 2012, 20:52	Laminar Finite-rate model Reaction Heat Release adjustment	#1
lam.nguyen New Member Nguyen Phuoc Lam, Eric Join Date: Jan 2012 Posts: 5 Rep Power: 14	Hi there, I am simulating a hydrogen combustion problem with global 1-step chemical reaction with laminar finite-rate model with FLUENT. However, I kept encountering auto-ignition problem due to finite heat release at room temperature. Can anyone offer me any advice as to how I can adjust the heat release rate for my model, say, if the temperature is below 500K, the heat release is set to 0, otherwise, the heat release calculated from the model is used. Regards,

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
heat release rate calculation	Karthick .K	FLUENT	2	April 28, 2021 22:15
heat release by surface reaction on walls	Marie-Anne	FLUENT	1	August 16, 2016 11:20
question about Heat transfer between two phases with VOF model	sooroo3	FLUENT	0	February 15, 2011 03:24
Natural convection - Inlet boundary condition	max91	CFX	1	July 29, 2008 20:28
Reaction rate model	wang	FLUENT	1	April 16, 2002 06:57

All times are GMT -4. The time now is 22:11.