|
[Sponsors] |
March 28, 2012, 21:21 |
polymer boundary layer
|
#1 |
New Member
Minjae Lee
Join Date: Mar 2012
Location: South Korea
Posts: 3
Rep Power: 14 |
Hello, I am solving the polymer extrusion problem.
I have a question that is the boundary layer of the polymer extrusion. The polymer metarial is sliding on the wall, then do I have to making the boundary layer? I do not think so, because the polymer has very high viscosity. The Reynolds number is less then 1.(Re<<1) |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
Grid Independence of Boundary layer | Luigi_ | Main CFD Forum | 0 | December 14, 2011 13:42 |
3D Boundary Layer | Mario | FLUENT | 0 | February 17, 2009 03:40 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |
boundary layer thickness | 98.4F | Main CFD Forum | 1 | December 29, 2000 07:23 |