|
[Sponsors] |
April 8, 2012, 17:24 |
considering flat furnace surface
|
#1 |
New Member
jorge
Join Date: Oct 2010
Posts: 7
Rep Power: 15 |
Dear all,
im modeling a 3D pulverized coal furnace, and (as many) im considering the tube walls has flat surface. The area reduction its from 1500 m2 to 750 m2. My question is that if the heat transfer it would be to much compromise with this approximation, considering has boundary condition that the walls are at a constant temperature = saturation temperature. regards George |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Surface mesh not sticking to surface | holtwong | ANSYS Meshing & Geometry | 2 | April 20, 2023 08:28 |
Different surface incident radiation between surface and surface-shadow | Cortomaltese | FLUENT | 0 | July 16, 2011 07:00 |
[ICEM] Automatic mesh generation script surface intersection problem | stuart23 | ANSYS Meshing & Geometry | 0 | May 13, 2011 01:10 |
Recover surface from surface mesh in IcemCFD | Jerry Tanner | CFX | 0 | August 20, 2008 12:48 |
free convection heat transfer from a heated horizontal surface through a liquid to a thin cooled fin | Kaushik | FLUENT | 1 | May 8, 2000 06:47 |