Mass flow rate.
Hi,
When i make a periodic boundary condition, fluent calculates inlet area based on z=1m by default, is there any way to change this z, or i just have to continue my mass flow rate calculation based on this inlet area. Thank you. |
Hi,
Any one have any suggestion about this problem, could i change this z or not?:confused: Thank you. |
Do you want to monitor the mass flow rate?
|
Hi,
I just want to make the inlet area in fluent equal to the real inlet area that i want it , and so not going through addittional calculation to adapt to fluent inlet area. Thank you for your reply. |
All times are GMT -4. The time now is 19:26. |