Mass flow rate.

A7A · April 15, 2012, 10:15

Hi,

When i make a periodic boundary condition, fluent calculates inlet area based on z=1m by default, is there any way to change this z, or i just have to continue my mass flow rate calculation based on this inlet area.

Thank you.

A7A · April 16, 2012, 13:17

Hi,

Any one have any suggestion about this problem, could i change this z or not?

Thank you.

Zigainer · April 16, 2012, 13:21

Do you want to monitor the mass flow rate?

A7A · April 16, 2012, 13:44

Hi,

I just want to make the inlet area in fluent equal to the real inlet area that i want it , and so not going through addittional calculation to adapt to fluent inlet area.

Thank you for your reply.

April 15, 2012, 10:15	Mass flow rate.	#1
A7A Member AHMAD Join Date: Apr 2012 Posts: 54 Rep Power: 0	Hi, When i make a periodic boundary condition, fluent calculates inlet area based on z=1m by default, is there any way to change this z, or i just have to continue my mass flow rate calculation based on this inlet area. Thank you. Last edited by A7A; April 15, 2012 at 18:28.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Particle Injection Mass Flow Rate and Position	leonozx	FLUENT	3	March 9, 2018 10:58
CFX turbo - Mass flow rate	Vashishth Patel	CFX	7	April 3, 2014 21:33
Mass flow rate at the outlet	tejasvikrishna	FLUENT	2	May 25, 2013 03:42
negative global mass flow rate	Gimli	FLUENT	0	April 21, 2006 08:17
mass flow rate error	Masood	FLUENT	0	May 22, 2005 01:32

April 16, 2012, 13:17		#2
A7A Member AHMAD Join Date: Apr 2012 Posts: 54 Rep Power: 0	Hi, Any one have any suggestion about this problem, could i change this z or not? Thank you.

April 16, 2012, 13:21		#3
Zigainer Senior Member Join Date: May 2011 Location: Germany Posts: 130 Rep Power: 16	Do you want to monitor the mass flow rate?

April 16, 2012, 13:44		#4
A7A Member AHMAD Join Date: Apr 2012 Posts: 54 Rep Power: 0	Hi, I just want to make the inlet area in fluent equal to the real inlet area that i want it , and so not going through addittional calculation to adapt to fluent inlet area. Thank you for your reply.