How to create a topology for tangential intersection of two cylinders

kmefun · July 5, 2016, 14:24

Hi,

Does anyone have the experiences for meshing the tangential intersection of two cylinder as the attached figure using Gridpro? It is a simplified geometry of cyclone separator with tangential injection. Dose anyone know how to create a topology for this kind of geometry? Any help is greatly appreciated.

Ken

vimaero · July 6, 2016, 04:59

Hi,

Check out their Youtube channel(GridPro Meshing). It has good number of videos.

These videos are similar to your case.

https://youtu.be/VJKnfUrk26g

https://youtu.be/xiHx5vF932U

Regards,
Vimal

kmefun · July 6, 2016, 10:18

Thanks Vimal.

July 6, 2016, 04:59	Video	#2
vimaero New Member Vimalraj Join Date: Apr 2013 Location: Bangalore Posts: 29 Rep Power: 12	Hi, Check out their Youtube channel(GridPro Meshing). It has good number of videos. These videos are similar to your case. https://youtu.be/VJKnfUrk26g https://youtu.be/xiHx5vF932U Regards, Vimal

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Meshing a Sphere	Ajay	FLUENT	10	September 3, 2016 15:18
Where's the singularity/mesh flaw?	audrich	FLUENT	3	August 4, 2009 02:07
ICEM topology	Igor-a	CFX	0	July 24, 2008 08:05
fluent add additional zones for the mesh file	SSL	FLUENT	2	January 26, 2008 12:55
meshing at a pipe intersection	cyn	FLUENT	0	December 20, 2006 03:16

July 6, 2016, 10:18		#3
kmefun Member Kaufman Join Date: Jul 2013 Posts: 55 Rep Power: 12	Thanks Vimal.