 |
 |
 |
|
|
|
[Sponsors] | ||||
July 2, 2012, 11:23
|
Convective/radiative ratio setting
|
#1 |
|
Member
yang
Join Date: Jun 2012
Posts: 39
Rep Power: 13  |
Dear all,
I have a question about convective/radiative ratio setting for the heat sources. E.g. for an occupancy who can produce about 100 W heat, if the convective/radiative ratio is 80/20, how could we set that in CFX-Pre? Please tell me the detailed setting process if you have some experience. Many thanks in advance! |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pressure eq. "converges" after few time steps | maddalena | OpenFOAM Running, Solving & CFD | 69 | July 21, 2011 07:42 |
| Cells with t below lower limit | Purushothama | Siemens | 2 | May 31, 2010 21:58 |
| setting value of turbulent intensity and turbulent viscosity ratio in wind tunnel | nuimlabib | Main CFD Forum | 0 | August 4, 2009 00:05 |
| grid expansion ratio setting | taw | Main CFD Forum | 1 | September 21, 2005 08:18 |
| Warning 097- | AB | Siemens | 6 | November 15, 2004 04:41 |
Linear Mode
