|
[Sponsors] |
July 14, 2012, 19:47 |
how to mesh multiparts as one body
|
#1 |
Member
yahya
Join Date: Jul 2012
Posts: 43
Rep Power: 13 |
I trying to mesh the flow inside a separator
I have a cylinder full of a fluid with two surface plates as internals When i meshed it i found that each part was meshed alone so i want to know to connect the meshing as one part in order to notice the influence of the plate on the flow behavior the attachment shows the separator that I'm meshing |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
[ICEM] Negative volume error in hybrid mesh | siw | ANSYS Meshing & Geometry | 4 | September 3, 2014 05:25 |
Mesh motion with Translation & Rotation | Doginal | CFX | 2 | January 12, 2014 06:21 |
Convergence moving mesh | lr103476 | OpenFOAM Running, Solving & CFD | 30 | November 19, 2007 14:09 |
Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 18:10 |