|July 24, 2012, 16:20||
Gorlov-vawt geometry issue
Join Date: Jul 2012
Location: Delft, Netherlands
Posts: 16Rep Power: 6
I´ve been asked to do some design changes in a helical-bladed VAWT at the research group of my school. The issue is that i got a baseline in which the blade geometry was created just by performing a "section protrusion" with three horizontal airfoils with a phase shift of 30 deg between airfoils. Does anyone knows about any procedure or standard technique for the generation of such geometries?
Thanks for reading!
|Thread||Thread Starter||Forum||Replies||Last Post|
|Rotor 67 full compressor geometry||jf||Main CFD Forum||1||May 26, 2015 10:48|
|[ICEM] Geometry too large!||brunorgs||ANSYS Meshing & Geometry||10||May 20, 2010 21:20|
|Problem meshing an imported geometry||Alicia||Open Source Meshers: Gmsh, Netgen, CGNS, ...||0||March 30, 2010 04:53|
|Input Geometry from Ideas to Gambit||Knick||FLUENT||2||December 11, 2002 04:59|
|Virtual/Real geometry.||Jack Keays||FLUENT||9||June 15, 2000 23:39|