Home > Forums > General Forums > Main CFD Forum

Solution of problem through Matrx Block Method

Mark Forums Read

Reply

Search this Thread

August 17, 2012, 05:10	Solution of problem through Matrx Block Method	#1
Naseem Ahmad New Member Prof. Naseem Ahmad Join Date: Aug 2012 Posts: 1 Rep Power: 0	Mx=c, where M is a matrim whose entreis are matrices and x and c are column matrices. This type of problems come when we go to Keller Box Method.

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Multiple fluide zone in ICEM Hexa Block problem	ddqp	ANSYS Meshing & Geometry	4	October 9, 2013 10:57
Solution convergence problem - poor mesh?	Shawn_A	OpenFOAM Running, Solving & CFD	2	November 12, 2011 19:31
a problem of incompressible two phases(water and gas) with VOF Method	zhangweisnoopy	Main CFD Forum	9	August 12, 2011 08:25
using ghost fluid method in shock tube problem	Amir	Main CFD Forum	4	February 24, 2011 10:09
Problem on high density ratio in Level Set method	Kai Yan	Main CFD Forum	10	December 25, 2007 06:12

All times are GMT -4. The time now is 18:40.