|
[Sponsors] |
January 25, 2006, 07:21 |
Wall function
|
#1 |
Guest
Posts: n/a
|
For a fine mesh (say y plus less than 3) a simulation was performed using standard wall function in two equation model for some iterations say 1500 and after that the wall function was removed and the run was carried out for another 1500 iterations. Whether the results after 3000 iteration will predicit the near wall behaviour correctly.
Thanks in advance. with regards Barani |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wall function for velocity? | johnblund | OpenFOAM | 3 | September 6, 2022 08:22 |
Compile problem | ivanyao | OpenFOAM Running, Solving & CFD | 1 | October 12, 2012 10:31 |
channelFoam for a 3D pipe | AlmostSurelyRob | OpenFOAM | 3 | June 24, 2011 14:06 |
Need some wall function approaches! | yka8150 | Main CFD Forum | 0 | September 22, 2009 00:08 |
[blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 15:00 |