|
[Sponsors] |
November 16, 2012, 10:15 |
problem about slip in microchannels
|
#1 |
New Member
ammm
Join Date: Nov 2012
Posts: 21
Rep Power: 13 |
Hello dear friends I want to simulate a microchannel and I want to put slip flow for it but I don’t know how much i should set in specified shear?
How can I put adhesion for it ?there is a phase in microchannel thank you |
|
November 16, 2012, 19:45 |
|
#2 |
Senior Member
ATM
Join Date: May 2009
Location: United States
Posts: 104
Rep Power: 16 |
Hi Ammm,
A suggestion: it would be better if you specify your question more clearly, especially as to what CFD package you are using. You may get more replies from people working in that area!! Good luck! a.t.m |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
area does not match neighbour by ... % -- possible face ordering problem | St.Pacholak | OpenFOAM | 10 | February 7, 2024 21:50 |
conduction problem | venkataramana | OpenFOAM | 3 | December 1, 2013 07:30 |
Problem Importing Geometry ProE to CFX | fatb0y | CFX | 3 | January 14, 2012 19:42 |
Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 19:13 |
Low-Pressure Boundary Slip | AlexA | FLUENT | 1 | January 5, 2007 21:30 |