CFD vs Test Pressure

dulalerbap · November 27, 2012, 16:10

Hi All:
I ran CFD simulation (FLUENT) of a component (many concepts to find the lowest pressure drop one) and then measured static pressure at several points to match. But what we found out that measured static pressure matches well with the CFD Total pressure (not static). Did anybody face this type of situation? Does anybody have any explanation/guess why this is happening?
-static pressure is measured by pressure transducer.

Thanks.

Engr.RZA · November 28, 2012, 10:18

Fluent gives the exact value of the static pressure even if you are using RANS instead of LES.

Give some details about the geometry and problem description then i can suggest whats happening in the flow.

dulalerbap · November 28, 2012, 12:25

Thanks RZA.
Basically two (2) pipes after the compressor going to a aftercooler. So pressure drop I was talking about is between the section : after the compressor (2 pipes) to the aftercooler (after two pipes merged) in to a rectangular section. So static pressure drop is negative (from theoretical point and FLUENT). But the test gives postive pressure drop which is similar to the total pressure drop from FLUENT.

November 27, 2012, 16:10	CFD vs Test Pressure	#1
dulalerbap New Member Join Date: Nov 2012 Posts: 5 Rep Power: 13	Hi All: I ran CFD simulation (FLUENT) of a component (many concepts to find the lowest pressure drop one) and then measured static pressure at several points to match. But what we found out that measured static pressure matches well with the CFD Total pressure (not static). Did anybody face this type of situation? Does anybody have any explanation/guess why this is happening? -static pressure is measured by pressure transducer. Thanks.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
"Pressure Inlet" Boundary Setup	Wijaya	FLUENT	15	May 18, 2016 10:08
Pressure Outlet Guage pressure	Mohsin	FLUENT	36	April 29, 2016 17:16
Does star cd takes reference pressure?	monica	Siemens	1	April 19, 2007 11:26
CFD versus Wind Tunnel Test	wuttichai	Main CFD Forum	3	November 12, 2003 00:07
what the result is negatif pressure at inlet	chong chee nan	FLUENT	0	December 29, 2001 05:13

November 28, 2012, 10:18		#2
Engr.RZA New Member RZA Join Date: Nov 2012 Posts: 25 Rep Power: 13	Fluent gives the exact value of the static pressure even if you are using RANS instead of LES. Give some details about the geometry and problem description then i can suggest whats happening in the flow.

November 28, 2012, 12:25		#3
dulalerbap New Member Join Date: Nov 2012 Posts: 5 Rep Power: 13	Thanks RZA. Basically two (2) pipes after the compressor going to a aftercooler. So pressure drop I was talking about is between the section : after the compressor (2 pipes) to the aftercooler (after two pipes merged) in to a rectangular section. So static pressure drop is negative (from theoretical point and FLUENT). But the test gives postive pressure drop which is similar to the total pressure drop from FLUENT.