CFD Online Logo CFD Online URL
Home > Forums > General Forums > Main CFD Forum

Comsol (4.3): convert parametric surface into block?

Register Blogs Members List Search Today's Posts Mark Forums Read

LinkBack Thread Tools Display Modes
Old   November 9, 2012, 10:20
Question Comsol (4.3): convert parametric surface into block?
New Member
Join Date: Nov 2012
Posts: 1
Rep Power: 0
sgalaz is on a distinguished road
I am new at Comsol (vn4.3.x) CFD and have a problem in creating a geomery:

I am not able to convert a parametric surface into a block for further manipulation and meshing. Please help!

Problem is the following:
I have to create a cubic volume, its lower boundary shall represent a rough surface. This surface comes out from a measurement and was successfully read in Comsol as a parametric surface. Viewed from above, this surface is a square.

Then, I draw a solid block around the parametric surface, so that the surface is located approximately in the middle of the block (cube).

Now I have to cut out the lower section of the block because it is not needed in solving the problem, I just need the upper part of the block in which the read-in surface would be the lower boundary.

Unfortunately, I do not find a way to do this. "Split" does not work. "Intersection" works only on solids and the surface is no solid, of course.

Converting the parametric surface into a solid in principal works - but the resulting surface/solid then vanishes from the "Graphics" window, so that I cannot select it with the mouse when I am attempting to intersect the two solids.

Also strange is, that I cannot extrude the parametric surface in order to get a block.

Does someone has a suggestion how to achieve what I want? I googled a lot and also looked into the Comsol forum,cbut couldn't find anything which helped.

sgalaz is offline   Reply With Quote


cad, comsol, cut, geometry, surface

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

Similar Threads
Thread Thread Starter Forum Replies Last Post
Problem with Gmsh nishant_hull Open Source Meshers: Gmsh, Netgen, CGNS, ... 23 August 5, 2015 02:09
How to convert DRM protected music and movies to MP4/AVI/MOV/MP3/WMV/AAC... urutyerid6 ANSYS 0 April 22, 2010 04:52
Icem Mesh to Foam jphandrigan OpenFOAM Mesh Utilities 4 March 9, 2010 03:58
Normal - Helical Surface m. malik Main CFD Forum 3 February 3, 2006 13:56
solid edge problem....can you help? cindy Main CFD Forum 3 April 5, 2004 13:43

All times are GMT -4. The time now is 04:01.