 |
 |
 |
|
|
|
[Sponsors] | ||||
March 3, 2006, 18:53
|
pressure correction at thita=0
|
#1 |
|
Guest
Posts: n/a
|
Hi! I am writing a code for a cylindrical grid in 3D.Can you suggest me an article that describes the boundary conditions at thita=0 or 360 degrees in the SIMPLE algorithm.Or can you describe me in detail? I need this detail,because I have implemented and something must be going wrong,but I can't figure out what. Thank you in advance!
|
|
|
||
|
March 5, 2006, 20:39
|
Re: pressure correction at thita=0
|
#2 |
|
Guest
Posts: n/a
|
What I would like to know is at the boundary conditions for the momentum equations, for the circumferential direction (thita) I set for thita=0 degrees,that is I=2, SU=SU+AE*U(1,J,K) and then AE=0.0 ,and so on for the other 2 momentum equations?
|
|
|
|
||
|
March 6, 2006, 17:58
|
Re: pressure correction at thita=0
|
#3 |
|
Guest
Posts: n/a
|
Isn't there anyone that has written a code for 3D cylindrical flow using pressure correction method to give me some advice?
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Strcture of pressure correction equation in PISO stable over time ? | sebi | Main CFD Forum | 1 | October 26, 2010 22:19 |
| changing the coefficients of pressure correction | Noel | Phoenics | 1 | April 7, 2009 08:54 |
| Pressure correction scheme in axissymmetric model | Adam Wu | Main CFD Forum | 0 | September 30, 2005 11:45 |
| residual in the pressure correction | George | Main CFD Forum | 2 | July 28, 2005 04:43 |
| a problem about pressure correction method | tommewang | Main CFD Forum | 2 | May 15, 2003 21:18 |
Linear Mode
