Home > Forums > General Forums > Main CFD Forum

CGNS Higher Blocking or Lower Blocking??

Mark Forums Read

Reply

Search this Thread

November 14, 2012, 12:49	CGNS Higher Blocking or Lower Blocking??	#1
drdr18 New Member diego flores Join Date: Apr 2009 Posts: 8 Rep Power: 17	Hi everyone, I want to know if there is any difference if I simulate a duct with 100 CGNS structured blocks or if I simplify and join these 100 blocks, namely, into 10 structured blocks. There will be some difference?? the results will be the same??

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[CGNS] CGNS converters available	mbeaudoin	OpenFOAM Meshing & Mesh Conversion	137	December 14, 2018 04:20
[ICEM] Blocking and Symmetry	BrolY	ANSYS Meshing & Geometry	32	August 24, 2012 03:13
[ICEM] Using Blocking with ICEM (infinite blocking lines appeared)	Touré	ANSYS Meshing & Geometry	2	August 5, 2012 17:27

All times are GMT -4. The time now is 08:38.