Dynamic mesh in axisymmetric modeling

Behnam Ghadimi · November 28, 2012, 04:25

Hello all
I tryed to model the oscillating piston in a cylinder using dynamic mesh option.
because of small gap between cylinder and piston I can not used the 3D model due to increasing the number of mesh. so I used 2D-axisymmetric model. but when Fluent want to update the mesh with remeshing option the axis is not deformed and the nagative volume error is shown.
can any one help me?
Do I need another UDF to deform the axis?
Ps.: Negative volume occures in the contraction side of axis.
Contraction side picture is attached.

adarshp2492 · January 26, 2017, 01:05

Did you solve this. I'm also having the same issue in a different geometry

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Dynamic Mesh on Pintle type injector.	herntan	FLUENT	16	September 4, 2020 08:27
potentialFreeSurfaceFoam with Dynamic Mesh	GuilhermeMP	OpenFOAM Programming & Development	1	October 6, 2013 03:05
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere!	sc298	OpenFOAM Meshing & Mesh Conversion	2	March 27, 2011 21:11
Problem with handling LES modeling with dynamic mesh	g.akbari	OpenFOAM Running, Solving & CFD	0	March 8, 2010 16:18
dynamic mesh and sliding mesh	nasser	FLUENT	0	November 1, 2005 02:37

January 26, 2017, 01:05		#2
adarshp2492 New Member Adarsh P Join Date: Aug 2016 Posts: 1 Rep Power: 0	Did you solve this. I'm also having the same issue in a different geometry