|May 8, 2006, 09:32||
ICEM CFD & Boundary Conditons
Could anyone please let me know how I can specify boundary conditions in ICEM in order to use my grid in FLUENT? Apparently, there should be a "translator" in "ouptput", but I can't find it, I have the full version of ICEM.
As a very simple test case, I have a stright cylinder, flow enters from one side and goes out fom the other side. So I need to specify INLET PRESSURE, OUTLET PRESSURE, FLUID (inside the duct) and SOLID (wall of the duct) boundary conditions. I am just stuck as to how to do it in ICEM.....because it is not possible to do this in FLUENT afterward.
Any idea/advice would be very much appreciated.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Domain Imbalance||HMR||CFX||5||October 10, 2016 05:57|
|inlet velocity boundary condition||murali||CFX||5||August 3, 2012 08:56|
|RPM in Wind Turbine||Pankaj||CFX||9||November 23, 2009 05:05|
|ICEM CFD License||boris||Main CFD Forum||3||March 15, 2004 01:16|
|ICEM CFD Modules||Boris||FLUENT||1||March 12, 2004 15:37|