Home > Forums > General Forums > Main CFD Forum

non-conformal mesh interface/ sliding mesh interface

Mark Forums Read

Reply

Search this Thread

March 19, 2013, 00:41	non-conformal mesh interface/ sliding mesh interface	#1
liladhar Member liladhar Join Date: May 2012 Posts: 35 Rep Power: 15	Hello everyone, i am attempting to simulate rotor and stator in a water jet duct. i am using star ccm v7.04. i am following the tutorial given in tutorial guide but unable to use the concepts to my problems. i am getting an error as'zero acceptor cells in region 1'. is there any problem with interface? if anybody wish to share their expertise and help me i will very greatefull to him/her.

Reply

Tags

non conformal interface, sliding mesh

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Moving mesh	Niklas Wikstrom (Wikstrom)	OpenFOAM Running, Solving & CFD	122	June 15, 2014 07:20
Mesh motion with Translation & Rotation	Doginal	CFX	2	January 12, 2014 07:21
Sliding Mesh/ Repeating interface	apc3161	STAR-CCM+	0	September 4, 2009 20:31
How to control Minximum mesh space?	hung	FLUENT	7	April 18, 2005 10:38
Replace periodic by inlet-outlet pair	lego	CFX	3	November 5, 2002 21:09

All times are GMT -4. The time now is 23:48.