|
[Sponsors] |
How to do boundary layer meshing in a 3D diffuser |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
How to do boundary layer meshing in a 3D diffuser using gambit.
|
|
![]() |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
Try to use G-Turbo, or you can discretize your domain into meshable sub-domains by using virtual split opitions.
|
|
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
A question on "Specifying Boundary Layer Deformation Smoothing" | didiean | FLUENT | 2 | January 16, 2012 21:39 |
Meshing cylinders with boundary layer using Gambit | Florence | ANSYS Meshing & Geometry | 5 | April 1, 2009 12:36 |
Inflation layers / boundary layer meshing. | andy2o | Main CFD Forum | 3 | February 22, 2009 09:03 |
Boundary Layer Meshing of a nosecone | Chris | FLUENT | 1 | March 15, 2005 12:42 |