CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > General Forums > Main CFD Forum

Pathlines Problem

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   May 7, 2013, 05:25
Default Pathlines Problem
  #1
New Member
 
Roberto
Join Date: Oct 2011
Location: Italy
Posts: 17
Rep Power: 14
Robbb is on a distinguished road
Hello everyone. I'm simulating a fluid flow through an helicoidal heat exchanger. The fluid (liquid) gets heated along the exchanger. When I'm post-processing the simulation and I'm trying to display pathlines starting from the inlet to calculate total temperature profiles along the exchanger, everything is ok but there's always one single pathline which doesn't escape the exchanger, or better.. this single pathline takes much longer to escape the exchanger. I've tried to change the flow rate entering the exchanger, but there's always the same problem. How can I fix this?
Robbb is offline   Reply With Quote

Old   May 7, 2013, 11:20
Default
  #2
Senior Member
 
Reza
Join Date: Mar 2009
Location: Appleton, WI
Posts: 116
Rep Power: 17
triple_r is on a distinguished road
Unfortunately, if there are recirculation zones in the solution domain, this can happen a lot. If the solution is steady state, then the recirculation zone should be a captured eddy (no mass exchange with outside of eddy), but because of numerical errors, even in steady state the eddy can exchange mass with outside. When this happens, and by bad luck, the particle that you are tracing enters the eddy, it takes a long time for it to get transferred outside (or it gets captured inside, recirculating over and over).

You can try refining your mesh near the recirculation zone, to remove some of those numerical errors, or let your solution run longer to get a better steady-state convergence. The other way is to trace a lot of particles, and ignore the ones that have a much longer residence time.

I hope this helps
triple_r is offline   Reply With Quote

Old   May 9, 2013, 09:49
Default
  #3
New Member
 
Roberto
Join Date: Oct 2011
Location: Italy
Posts: 17
Rep Power: 14
Robbb is on a distinguished road
I tried to extend the convergence to from E-06 to E-8, but it still doesn't work. I should probably modify the mesh, but the geometry is really complex and I actually can't understand where are the problems. I think I'll try something else.
Robbb is offline   Reply With Quote

Reply

Tags
heat exchanger, pathline, pathlines

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
UDF compiling problem Wouter Fluent UDF and Scheme Programming 6 June 6, 2012 05:43
Gambit - meshing over airfoil wrapping (?) problem JFDC FLUENT 1 July 11, 2011 06:59
natural convection problem for a CHT problem Se-Hee CFX 2 June 10, 2007 07:29
Adiabatic and Rotating wall (Convection problem) ParodDav CFX 5 April 29, 2007 20:13
Is this problem well posed? Thomas P. Abraham Main CFD Forum 5 September 8, 1999 15:52


All times are GMT -4. The time now is 04:42.