|August 24, 2006, 10:43||
MISES error message
I've just started using MISES for the analysis of the flow through a turbine cascade. Could anyone of you explain the meaning of the following error message,
"Array overflow. Increase IQX",
that I get during the grid initialization for the 'panel solution'?
Thank you in advance
|August 25, 2006, 16:56||
Re: MISES error message
IQX mast be a paramiter (if misses is in fortran)just increase it ! (your grid is larger than your arrey)
p.s. i thing !! i hope i did't confuse you..
|March 19, 2010, 08:25||
Join Date: Mar 2010
Posts: 2Rep Power: 0
Has this been figured out? I get the following message:
Reading in coordinate file for: Vane 1
Coordinates read from file blade.v1
Blade 1: 178 points. Sharp leading edge.
File read error: stream.v1
Default 2-D X,R,B used.
File read error: loss.v1
Zero prescribed pressure loss assumed.
Calculating unit vorticity distributions ...
File read error: gridpar.v1
Default grid parameters used.
Generating panel solution ...
Sinl = 0.000 Sout = -0.528 Cy = 0.1112 Cx = 0.0302
Setting wake for blade 1
Setting inlet streamline for blade 1
INLSET: Array overflow. Increase IQX.
MISES is sold under a commercial license. I do not have access to the source code so I can't change any parameters (i.e. IQX) in the code. My only handle are control files - but I can't find IQX anywhere ...
|June 4, 2013, 11:29||
Join Date: Sep 2011
Posts: 12Rep Power: 7
check your blade.xxx file for identically blade pairs, like:
MISES can not handle this.
|Thread||Thread Starter||Forum||Replies||Last Post|
|MISES code for analysis of cascade flows||Quamber H. Nagpurwala||Main CFD Forum||12||September 5, 2016 04:01|
|MISES, radial turbomachinery||arapha||Main CFD Forum||0||September 8, 2011 09:13|
|stress analysis -Von Mises Theory||watashiwa||OpenFOAM||7||October 15, 2010 15:43|
|MISES error||abhishek||Main CFD Forum||3||October 26, 2007 02:26|
|mises transform||rameez||Main CFD Forum||1||January 18, 2000 15:26|