|
[Sponsors] |
July 23, 2013, 19:36 |
remesh to solve error
|
#1 |
New Member
ravi
Join Date: Jul 2013
Posts: 12
Rep Power: 12 |
ERROR: Tetrahedral meshing has failed for volume outer.
This is usually caused by problems in the face meshes. Check the skewnesses of your face meshes and make sure the face mesh sizes are not too large in areas of small gaps. Actually, I have a truck placed in wintunnel, I could get the results. But when I add devices to it, and try to mesh it again I'm getting the above error. Any suggestions. Last edited by pendyala; July 23, 2013 at 20:10. Reason: Error I copied from one post, so had to change few details |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Pressure outlet boundary condition | rolando | OpenFOAM Running, Solving & CFD | 62 | September 18, 2017 06:45 |
[swak4Foam] installing funkySetFields | igo | OpenFOAM Community Contributions | 1 | November 20, 2012 20:16 |
Ansys Fluent 13.0 UDF compilation problem in Window XP (32 bit) | Yogini | Fluent UDF and Scheme Programming | 7 | October 3, 2012 07:24 |
[swak4Foam] groovyBC: problems compiling: "flex: not found" and "undefined reference to ..." | sega | OpenFOAM Community Contributions | 12 | February 17, 2010 09:30 |
Version 15 on Mac OS X | gschaider | OpenFOAM Installation | 113 | December 2, 2009 10:23 |