Need help about irregular surface values -- CFD Online Discussion Forums

August 4, 2013, 20:11

Need help about irregular surface values

highhopes

Member

Join Date: Feb 2011

Posts: 56

Rep Power: 12

Dear Fluent users,

Simple question, why do you think there are irregular pressure values on the surfaces in the pictures below?
Using RNG, enhanced wall treatment with yplus 1, tried second and third order schemes, constructed a block structured mesh and generated geometry using icem cfd.

Attached Images

	pressure.jpg (92.7 KB, 2 views)
	suction.jpg (94.7 KB, 1 views)

Last edited by highhopes; August 5, 2013 at 14:40. Reason: The pictures were not uploaded successfully

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
TimeVaryingMappedFixedValue	irishdave	OpenFOAM Running, Solving & CFD	31	January 25, 2018 04:03
[snappyHexMesh] Snap Precision to a STL Surface	malaboss	OpenFOAM Meshing & Mesh Conversion	16	July 26, 2013 02:44
[ICEM] How to generate sunstructured "all-tri patch-dependant" surface mesh in ICEM?	jash	ANSYS Meshing & Geometry	19	July 23, 2013 19:48
[snappyHexMesh] snappyHexMesh aborting	Tobi	OpenFOAM Meshing & Mesh Conversion	0	November 10, 2010 04:23
Heat flux on a irregular surface	massimo	Siemens	5	December 11, 2002 06:55

All times are GMT -4. The time now is 06:12.