|August 5, 2013, 03:57||
Presure Field Not Converged in FSI using Ansys-CFX Coupling
Join Date: Mar 2013
Posts: 14Rep Power: 5
Hi Every body
I'm simulating FSI case of interaction between an Airfoil(NACA0012) and air.
i first run steady state Fluid only simulation and after use it as initial condition for my FSI problem.
in FSI case i also use constant flow of 10[m/s] as in steady case, so i should see no change in pressure and velocity fields, but i see that from first time step although the velocity field keeps the same, but pressure field not solved good and in fact is Funny( i attached my pressure counter) !!
for inlet i set velocity(10[m/s]) and for outlet relative static pressure = 0
i have a C-mesh
i will thank a lot for Anybody helps me
|Thread||Thread Starter||Forum||Replies||Last Post|
|Problem in coupling CFX and Ansys for fluid-thermal sim.||Jordi||CFX||17||February 19, 2017 18:42|
|2way FSI with Ansys workbench||lingdeer||ANSYS||3||May 9, 2013 03:48|
|Ansys + Fluent 2-way FSI coupling||raditz||FLUENT||2||February 14, 2013 15:37|
|Restart FSI run on ANSYS CFX||lingdeer||CFX||3||October 10, 2011 09:47|
|Properly using symmetry with both CFX and ANSYS workbench for a FSI analysis, help!||Cirion0000||CFX||0||July 6, 2009 14:26|