 |
 |
 |
|
|
|
[Sponsors] | ||||
September 18, 2006, 04:40
|
BC for o-grid help
|
#1 |
|
Guest
Posts: n/a
|
May I know what should be the boundary condition for a cylinder in free stream in an o-grid?
I wonder if this is correct: flow is coming from left to right fixed inlet velocity for outer mesh on left half of o-grid assign du/dn and dv/dn for outer mesh on right half of o-grid no slip velocity for mesh next to cylinder surface dp/dn=0 on all edges except that at right half of o-grid, p=0 (equal to fixing outlet pressure) Hope someone can give me some help. Thank you. |
|
|
||
|
September 18, 2006, 07:48
|
Re: BC for o-grid help
|
#2 |
|
Guest
Posts: n/a
|
Sounds reasonble.
Dont forget to test the result sensitivity to your BC locations. |
|
|
|
||
|
September 18, 2006, 16:14
|
Re: BC for o-grid help
|
#3 |
|
Guest
Posts: n/a
|
what about boundary conditions on symetrical airfoil in O-grid, is that the same as cylinder?
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| MapFields to New Grid For Extreme Grid Deformations due to Body Motion | albcem | OpenFOAM | 0 | May 5, 2009 14:17 |
| Grid Adaptation | Suresh | FLUENT | 0 | October 15, 2003 13:18 |
| GRID TO GRID INTERPOLATION in FLUENT | calogero | FLUENT | 3 | June 4, 2003 08:32 |
| Combustion Convergence problems | Art Stretton | Phoenics | 5 | April 2, 2002 05:59 |
| Troubles modelling flow through a grid | Hans Klaufus | CFX | 1 | June 28, 2000 16:43 |
Linear Mode
