|
[Sponsors] |
September 11, 2013, 10:01 |
Mass transfer
|
#1 |
New Member
Andrew Walmsley
Join Date: Sep 2013
Posts: 5
Rep Power: 12 |
Hi,
I'm quite new here, I'm running a multi species simulation and just looking for some advice on the theory side. My simulation only correctly shows the injected species if I activate the inlet diffusion term. However I was made to understand that if the peclet number is above one then it should be disabled? I've struggled to find any written information on this so I was just wondering if anyone here has experience. As a side question, is anyone aware of a good book covering mass transfer, diffusion and possibly that aspect of CFD such as information on when inlet diffusion needs to be enabled? Thanks for any help. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
mass transfer in ANSYS | thipps | ANSYS | 1 | August 29, 2013 11:05 |
Error finding variable "THERMX" | sunilpatil | CFX | 8 | April 26, 2013 07:00 |
How to calculate Volumetric Mass transfer coefficient using CFX? | tuks_123 | CFX | 2 | July 22, 2010 01:15 |
Vof, udf and mass transfer panel | Jay | FLUENT | 1 | March 15, 2005 00:29 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |