 |
 |
 |
|
|
|
[Sponsors] | ||||
November 13, 2006, 04:42
|
Parts not exported????
|
#1 |
|
Guest
Posts: n/a
|
Hey. The following question stands:
"How can it be, tha when i generate my mest in Icem in 2D, and then extrude to 3D - and create a output file to cfx - my PARTS (geometri parts: Inlet/outlet) are not exportet/visible in CFX????" Please do help, if you know the awnser to this question! Best Regards Jesper |
|
|
||
|
November 14, 2006, 07:41
|
Re: Parts not exported????
|
#2 |
|
Guest
Posts: n/a
|
A solution is found!!!
|
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ICEM won't let me delete parts | Jesus | CFX | 3 | November 9, 2015 17:45 |
| How to handle suction and pressure side of an airfoil as two different parts? | TKE | ANSYS Meshing & Geometry | 4 | March 17, 2011 07:49 |
| How to handle suction and pressure side of an airfoil as two different parts? | TKE | ANSYS Meshing & Geometry | 0 | March 4, 2011 08:48 |
| Creating 100 derived parts / Splitting derived parts for mass flux calculation | xamo | STAR-CCM+ | 8 | September 29, 2009 06:35 |
| [snappyHexMesh] SnappyHexMesh complex geometries amp thin wall parts | hsieh | OpenFOAM Meshing & Mesh Conversion | 0 | September 22, 2008 18:34 |
Linear Mode
