|
[Sponsors] |
December 19, 2006, 11:21 |
Node numbering at interface in MeTiS.
|
#1 |
Guest
Posts: n/a
|
Hi i have done mesh partition using MeTiS. It has given me .npart and .epart file. I know that it gives me information of nodes and elements in each partition. My problem is that how it writes node array of any domain ? i.e. suppose my domain contains 12 nodes and 12 elements, then metis gives me partition which gives me 2 parts, each containing 6 elments a. but what is about nodes? and specifically what is about nodes at interface. i.e. how metis will decide about nodes on interface that , this node will go in partion 1 or 2. i.e. how node numbering is done in metis? Pls help me. Thanks mehul
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 60 | July 17, 2024 06:45 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 05:05 |
Node numbering at interface in MeTiS. | mehul | FLUENT | 0 | December 19, 2006 11:22 |
Node numbering at interface in MeTiS. | mehul | CFX | 0 | December 19, 2006 11:22 |
Replace periodic by inlet-outlet pair | lego | CFX | 3 | November 5, 2002 21:09 |