 |
 |
 |
|
|
|
[Sponsors] | ||||
March 13, 2007, 11:44
|
LOW REYNOLD NUMBER
|
#1 |
|
Guest
Posts: n/a
|
Hello everyone. Im simulating a separator and the Reynold number is too slow. The velocities inside de equipment are about 0.3M/S. Consider that the diameter is 27''. Im having problems with the simulation, i think that its because of the turbulence model. What turbulence model should i use to model LOW REYNOLDS NUMBER?
|
|
|
||
|
March 13, 2007, 12:37
|
Re: LOW REYNOLD NUMBER
|
#2 |
|
Guest
Posts: n/a
|
None.
|
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [mesh manipulation] Mesh Refinement | Luiz Eduardo Bittencourt Sampaio (Sampaio) | OpenFOAM Meshing & Mesh Conversion | 42 | January 8, 2017 13:55 |
| Unaligned accesses on IA64 | andre | OpenFOAM | 5 | June 23, 2008 11:37 |
| About low Reynolds number airfoil experiment data. | zqnwpu | Main CFD Forum | 5 | December 25, 2004 04:52 |
| Multicomponent fluid | Andrea | CFX | 2 | October 11, 2004 06:12 |
| how calculate the density in low mach number? | Juhee Lee | Main CFD Forum | 1 | July 31, 1999 16:26 |
Linear Mode
