|
[Sponsors] |
test prob for 2D unsteady navier stokes equation |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
hi friends
I am looking for test problems for my 2d unsteady Incompressible Navier Stokes equations flow solver . plz help/ suggest thanks |
|
![]() |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
Dear Shah,
I would suggest that you start off with the laminar vortec shedding past cylinder. This problem is very well documented and can therefore be easily validated. Other problems include airfoils at higher angles of attack and flows past bicircular airfoils. Hope this helps Regards, Ganesh |
|
![]() |
![]() |
![]() |
#3 |
Guest
Posts: n/a
|
Taneda, S., and Honji, H., Unsteady Flow Past a Flat Plate Normal to the Direction of Motion," J. Phys. Soc. Japan , Vol. 30, pp. 262-273, 1971.
|
|
![]() |
![]() |
![]() |
#4 |
Guest
Posts: n/a
|
||
![]() |
![]() |
![]() |
#5 |
Guest
Posts: n/a
|
You can tke flow across stationary circular cylinder for Re>60 sachin
|
|
![]() |
![]() |
![]() |
#6 |
Guest
Posts: n/a
|
I will try to post some results by the end of the week including comparisons. The basic data product is the recirculation length behind the obstacle as a function of the evolving simulation time.
|
|
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
need 2d equation for navier stokes in c | sudeep | FLUENT | 1 | February 16, 2011 17:01 |
critical error during installation of openfoam | Fabio88 | OpenFOAM Installation | 21 | June 2, 2010 03:01 |
OF 1.6 | Ubuntu 9.10 (64bit) | GLIBCXX_3.4.11 not found | piprus | OpenFOAM Installation | 22 | February 25, 2010 13:43 |
Problems in compiling paraview in Suse 10.3 platform | chiven | OpenFOAM Installation | 3 | December 1, 2009 07:21 |
Exact unsteady Stokes test case | neazen | Main CFD Forum | 5 | April 13, 2009 14:15 |