|
[Sponsors] |
April 29, 2007, 10:04 |
flat palte boundzry layer
|
#1 |
Guest
Posts: n/a
|
helo sir, im solving Flat Plate boundary layer the conditions i applied are entrance : u=1;v=0;dp/dx=0; exit : du/dx=0;dv/dx=0;p=0; top : u=1, v=0;p=0; bottom : u=v=0;dp/dy=0;
size of the domain 20:4; the problem im facing is i have got velocity greater than one. this is due to maintain the conservation of mass. ie at the entrance u=1 it has some mass in this control volume. in the downstream due to boundary layer there is a reduciton in velocity at the bottom, but inorder to maintain the mass conservation it increases the velocity greater than one. so plz let me the correct boundary condition. thanks in advance |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] SnappyHexMesh - no layer added | bejbro | OpenFOAM Meshing & Mesh Conversion | 5 | February 1, 2020 20:05 |
[snappyHexMesh] Boundary layer in a pipe | Clementhuon | OpenFOAM Meshing & Mesh Conversion | 6 | March 12, 2012 12:41 |
[snappyHexMesh] Boundary layer generation problems | ivan_cozza | OpenFOAM Meshing & Mesh Conversion | 0 | October 6, 2010 13:47 |
errors | Fahad | Main CFD Forum | 0 | March 23, 2004 13:20 |
flat plate boundary layer data | Ekachai Juntasaro | Main CFD Forum | 3 | March 13, 2001 23:18 |