|
[Sponsors] |
September 20, 2007, 13:40 |
Multiple Inlet Problems
|
#1 |
Guest
Posts: n/a
|
I have a mesh of a simple mixing pipe with a main flow being mixed with a smaller pipe at a 90degree elbow. i have meshed and set boundary conditions 2 inlets and one outlet in gambit. exporting the mesh was sucessful, however when displaying the grid in fluent 5, there are no inlet boundary conditions. is there any reason for this?
much apprietiated. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Multiple domain/Multiple material problems... possible or not? | Amiga500 | OpenFOAM | 1 | April 14, 2010 15:32 |
Inlet Velocity in CFX | aeroman | CFX | 12 | August 6, 2009 18:42 |
Problems with Inlet species | San24 | Siemens | 1 | May 7, 2008 06:29 |
what the result is negatif pressure at inlet | chong chee nan | FLUENT | 0 | December 29, 2001 05:13 |
Inlet diffuser of ramjet | Mohammad Kermani | Main CFD Forum | 25 | December 29, 2000 18:46 |