 |
 |
 |
|
|
|
[Sponsors] | ||||
October 11, 2007, 05:20
|
3D duct bending at 90 degrees
|
#1 |
|
Guest
Posts: n/a
|
I'm strugling to bend a 0.3 diameter cylinder at 90 degrees. Its actually a circular duct coming into a room from an evaporative cooler. I'm strugling to make the bend.
|
|
|
||
|
October 11, 2007, 05:37
|
Re: 3D duct bending at 90 degrees
|
#2 |
|
Guest
Posts: n/a
|
struggling to make the bend means??? r u not able to use CAD tools to make the bend or r u facing problems in meshing?
|
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Fabric Duct Modeling | Dan | FLUENT | 1 | September 27, 2024 04:43 |
| Total pressure increase in the diverging duct | shiv | Siemens | 3 | February 1, 2008 04:39 |
| modelling fuel cell duct in fluent | rajesh kumar tippabhotla | FLUENT | 2 | October 7, 2004 13:04 |
| Airpak: natural convection in a duct | NeOmega | FLUENT | 2 | August 27, 2004 14:28 |
| flow simulation across a small fan | jane luo | Main CFD Forum | 15 | April 12, 2004 18:49 |
Linear Mode
