MISES error

October 23, 2007, 04:30

Hi

Started using MISES software for analyzing turbine cascade. Could anyone please help with the following error message. There is some problem with panel solution.

Coordinates read from file blade.

Blade 1: 261 points

File read error: stream. Default 2-D X,R,B used.

File read error: loss. Zero prescribed pressure loss assumed.

Calculating unit vorticity distributions ...

File read error: gridpar. Default grid parameters used.

Generating panel solution ...

Sinl = 0.578 Sout = nan Cy = nan Cx = nan

Setting wake for blade 1 STOP WAKSET: Array overflow. Increase IQX. statement executed

Thank you in advance.

October 23, 2007, 07:56

Probably there is something wrong with the user!

October 24, 2007, 04:19

All the inputs are correct, still the same error is shown.

October 26, 2007, 02:26

The problem is solved. The input file had tab characters,which are not recognized by standard Fortran 77 or the g77 compiler. So replacing tabs with spaces solved the issue.

October 23, 2007, 04:30	MISES error	#1
abhishek Guest Posts: n/a	Hi Started using MISES software for analyzing turbine cascade. Could anyone please help with the following error message. There is some problem with panel solution. Coordinates read from file blade. Blade 1: 261 points File read error: stream. Default 2-D X,R,B used. File read error: loss. Zero prescribed pressure loss assumed. Calculating unit vorticity distributions ... File read error: gridpar. Default grid parameters used. Generating panel solution ... Sinl = 0.578 Sout = nan Cy = nan Cx = nan Setting wake for blade 1 STOP WAKSET: Array overflow. Increase IQX. statement executed Thank you in advance.

October 23, 2007, 07:56	Re: MISES error	#2
Hatef Guest Posts: n/a	Probably there is something wrong with the user!

October 24, 2007, 04:19	Re: MISES error	#3
abhishek Guest Posts: n/a	All the inputs are correct, still the same error is shown.

October 26, 2007, 02:26	Re: MISES error	#4
abhishek Guest Posts: n/a	The problem is solved. The input file had tab characters,which are not recognized by standard Fortran 77 or the g77 compiler. So replacing tabs with spaces solved the issue.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
CGNS Compiling	Diego	Main CFD Forum	17	December 21, 2014 01:40
Accessing phi from a fvPatchField at same patch	johndeas	OpenFOAM	1	September 13, 2010 20:23
Problem with compile the setParabolicInlet	ivanyao	OpenFOAM Running, Solving & CFD	6	September 5, 2008 20:50
Compiling problems with hello worldC	fw407	OpenFOAM Installation	21	January 6, 2008 17:38
user defined function	cfduser	CFX	0	April 29, 2006 10:58