 |
 |
 |
|
|
|
[Sponsors] | ||||
November 15, 2014, 10:12
|
Mesh motion updating issue
|
#1 |
|
New Member
Saurabh Kumar
Join Date: Nov 2014
Posts: 1
Rep Power: 0  |
Hi all,
I am using a transient sliding mesh model to model a torque converter.. The model runs and converges fine on every time step. But after a few time-steps (79 in this case), the next step just can't load.. the message in TUI is Updating solution at time level N... done. and it's just stuck after that. Any suggestions? |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
| [ICEM] Generating Mesh for STL Car in Windtunnel Simulation | tommymoose | ANSYS Meshing & Geometry | 48 | April 15, 2013 04:24 |
| Prescribed mesh motion does not correspond to actual motion | rbarrett | CFX | 8 | June 30, 2011 13:22 |
| Discrete Values for Mesh Motion | UnderwaterAlex | CFX | 2 | February 21, 2008 18:21 |
| large scale mesh motion | sb | FLUENT | 1 | April 27, 2007 22:23 |
Linear Mode
