|
[Sponsors] |
February 12, 2008, 05:57 |
WARNING 221060 No upwind nodes found...
|
#1 |
Guest
Posts: n/a
|
Hi, I am simulating injection moulding with a polymer insert in Moldflow, when I get a whole of these warnings:
** WARNING 221060 ** No upwind nodes found during temperature convection at node 191889 The flow gets weird at the time, when the warnings begin. Does anyone have tips about what it means. Thanks. Mattias |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[swak4Foam] installing funkySetFields | prapanj | OpenFOAM Community Contributions | 65 | October 8, 2015 17:46 |
Cells with t below lower limit | Purushothama | Siemens | 2 | May 31, 2010 21:58 |
latest OpenFOAM-1.6.x from git failed to compile | phsieh2005 | OpenFOAM Bugs | 25 | February 9, 2010 04:37 |
Version 15 on Mac OS X | gschaider | OpenFOAM Installation | 113 | December 2, 2009 10:23 |
[blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |