|
[Sponsors] |
February 15, 2008, 16:43 |
Runing a simulation
|
#1 |
Guest
Posts: n/a
|
I am running simulations on a supersonic impinging jet. So far I have run it for t = 5 which in dimensional time is on the order of 10e-4 sec. The simulation starts with the jet exiting from the nozzle.
I am guessing in an experiment you would run the jet for a couple of seconds before taking measurements. So maybe I should do the same in the simulation. I'll have to run it on supercomputers though. Shuo |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Why my simulation not agree with the wind tunnel experiment | zhaowei | CFX | 4 | July 11, 2015 03:36 |
Solar Radiation in OpenFOAM | plainstyle | OpenFOAM Running, Solving & CFD | 15 | July 8, 2014 04:43 |
Axial fan simulation in UG/NX 7.5 | fan123 | Main CFD Forum | 2 | April 23, 2011 08:22 |
Simulation of a complex wing in solidworks flow simulation | niels1900 | FloEFD, FloWorks & FloTHERM | 6 | April 20, 2011 10:44 |
strange simulation error | Ralf Schmidt | FLUENT | 2 | May 4, 2007 13:02 |