CFD Online Discussion Forums

CFD Online Discussion Forums (https://www.cfd-online.com/Forums/)
-   Main CFD Forum (https://www.cfd-online.com/Forums/main/)
-   -   about merge mesh (https://www.cfd-online.com/Forums/main/14867-about-merge-mesh.html)

lian February 28, 2008 15:19

about merge mesh
 
hello,everyone, I have a question about merge mesh. I want to merge two mesh (hexa and tetra). Before merge I have checked the grid quality of hexa and tetra, not bad,hexa is 0.4, tetra is o.25. but after merge mesh ,the grid quality is very low, the grids with low quality are the pyramid grids on interface, who can tell me,how to solve this problem?? how to improve the quality of pyramid grids after merge mesh ?? (I have used the smooth mesh option,but it is not work ) thanks for answer .

Air Bag February 28, 2008 17:25

Re: about merge mesh
 
It could be helpful if you tell us which software you are using.

lian February 28, 2008 17:47

Re: about merge mesh
 
sorry, I forget to say, I use ICEM

myron February 29, 2008 11:47

Re: about merge mesh
 
Best to make the quads and tris on the boundary as close to the same size as possible (edge lengths). That usually provides a less-skewed pyramid. You can also smooth after-the-fact. (But freeze the hex elements.)


All times are GMT -4. The time now is 05:29.