Airflow due to pressure differences

FUDM · February 27, 2015, 17:12

Hello!

I'm new at working with CFD software, so my knowledge is very limited.

I'm working on a simulation using CFD commercial program Flow-3D. My goal is to simulate the airflow between two adjacent rooms, through a small hole. The rooms would have a pressure difference between them of -50 Pa (de-pressurization), meaning one room would suck air from the other. The results will then be compared with a blower door test.

Can anyone give me some tips on how to perform this simulation, such as boundary conditions and other important parameters?

Thank you.

charles4allme · December 16, 2019, 15:51

Hey,

Were you able to figure it out

February 27, 2015, 17:12	Airflow due to pressure differences	#1
FUDM New Member Fábio Join Date: Feb 2015 Posts: 14 Rep Power: 12	Hello! I'm new at working with CFD software, so my knowledge is very limited. I'm working on a simulation using CFD commercial program Flow-3D. My goal is to simulate the airflow between two adjacent rooms, through a small hole. The rooms would have a pressure difference between them of -50 Pa (de-pressurization), meaning one room would suck air from the other. The results will then be compared with a blower door test. Can anyone give me some tips on how to perform this simulation, such as boundary conditions and other important parameters? Thank you.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
InterPhaseChangeFoam ERROR	shipman	OpenFOAM Running, Solving & CFD	37	March 23, 2014 13:43
Cfx aborted due to unknown errors	AKHILESH S L	CFX	2	October 10, 2013 18:16
rhoPimpleFoam Initial Setup Queries for a Flow Generated due to Pressure B.C	umer.chaudrey	OpenFOAM	1	October 4, 2011 04:52
Pressure BC for combustion chamber	Giuki	FLUENT	1	July 19, 2011 12:35
Pressure Rise Error	emueller	CFX	0	May 5, 2009 12:08

December 16, 2019, 15:51		#2
charles4allme Member Join Date: Feb 2018 Posts: 91 Rep Power: 9	Hey, Were you able to figure it out