|
[Sponsors] |
April 30, 2015, 17:03 |
Converging diverging pipe in bigger pipe
|
#1 |
New Member
Join Date: Mar 2015
Posts: 4
Rep Power: 11 |
Hi everyone,
What is the best way or method to simulate flow in converging/diverging pipe placed in a bigger one? Inlet velocity should be from laminar to turbulent flow and size of the smallest part of the inner pipe should vary too... In definitive, laminar and turbulent flow could be both present but I can't predict it (except for the inlet). Any advice is welcome. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[DesignModeler] DesignModeler Pipe within pipe | shields | ANSYS Meshing & Geometry | 13 | November 25, 2018 22:14 |
Converging Diverging Nozzle in OpenFOAM | danishdude | OpenFOAM Running, Solving & CFD | 1 | September 15, 2012 00:12 |
[DesignModeler] How to create smaller pipe inside bigger pipe? | Munggang | ANSYS Meshing & Geometry | 2 | March 7, 2012 14:01 |
Terrible Mistake In Fluid Dynamics History | Abhi | Main CFD Forum | 12 | July 8, 2002 09:11 |
fluid flow fundas | ram | Main CFD Forum | 5 | June 17, 2000 21:31 |