Home > Forums > General Forums > Main CFD Forum

Rotation in STAR-DESIGN.. How?

Mark Forums Read

Reply

Search this Thread

August 27, 2008, 19:56	Rotation in STAR-DESIGN.. How?	#1
famy Guest Posts: n/a	I wish someone would help and guide me in doing model rotation using STAR-DESIGN. There is a step on how to rotate the model, but if i run the volume mesh, the meshing failed. I am using the STAR-DESIGN in STAR-CD software.

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Commercial meshers] Using starToFoam	clo	OpenFOAM Meshing & Mesh Conversion	33	September 26, 2012 04:04
[Other] StarToFoam error	Kart	OpenFOAM Meshing & Mesh Conversion	1	February 4, 2010 04:38
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues	michele	OpenFOAM Meshing & Mesh Conversion	2	July 15, 2005 04:15
Star Design to Star-CD(Prostar)	AB	Siemens	5	October 28, 2004 12:21
Info: Short Course On Thermal Design of Electronic Equipment	Arnold Free	Main CFD Forum	0	August 10, 1999 10:18

All times are GMT -4. The time now is 21:34.